Vetala Forum

I've had a few instances of maya crashing during the build process.
After restarting I am unable to access the files through Vetala. Under type it says 'non-vetala-folder'
I am still able to open the file if i browse to the file.
I was wondering if there was a quick way to repair this in Vetala so i can use it without having to make a new one?

If you right click on the gray folder there is an option to "Convert Folder to Process"

Sorry, after re-reading your post I can see that you are talking about data folders. There's currently no built in way for doing this.


In the below example you can see that the control_cvs data's data.type file has the correct data type. However the control_cvs1 data.type file does not. Replacing "None" with "maya.control_cvs" fixes the issue.